800.852.8352
Fax: 937.866.4174
Midwest Fasteners, Inc.
450 Richard St.
Miamisburg, OH 45342
|
|
CD 700
CAPACITOR DISCHARGE
STUD WELDER
|
 |
| The CD 700 Stud Welder from Midwest Fasteners is designed specifically for the insulation contractor. In fact, it is one of the most powerful capacitor discharge units available today. The CD 700 features a separate cup head weld pin contact mode that welds to materials as thin as 20 gauge - without fear of burn through. A unique feature is the 84,000 to 168,000 MFD variable capacitance high/low power range switch which handles the toughest applications. The high power range helps eliminate surface preparation when welding "Power Tip" pins from Midwest Fasteners.
The unit's solid state circuitry lowers maintenance costs, since moving parts are eliminated. And the rugged steel chassis makes the CD 700 able to withstand the rigors of construction jobsites. Gauges and control knobs are protected by a recessed control panel. Circuit breaker protection prevents expensive repair to component parts, such as printed circuit boards. The auto fault shut-off adds to operator safety, and the panel meter displays capacitor discharge voltage at a glance.
|
An ultra-light 24 ounce precision Contact Gun is included with the CD 700 system. With this Gun, operator fatigue is reduced --- thereby increasing production. The weld gun also features interchangeable main spring pressure that is necessary for many special welding applications, and critical in welding aluminum fasteners and dissimilar material. The unique drilled-through gun shaft enables precise gun set up for welding aluminum pins and extra long CD weld pins.
The CD 700 Capacitor Discharge Stud Welder. Available only from Midwest Fasteners --your complete source for insulation fastening.
|
CD 700
CAPACITOR DISCHARGE
WELDING SYSTEM |
 |
SPECIFICATION |
POWER |
| SUPPLY / CONTROLLER |
| Height |
9" |
| Width |
13-1/2" |
| Depth |
21" |
| Weight |
66 Pounds |
| Capacitance |
Low - 84,000 mfd |
| |
High - 168,000 mfd |
| Weld Rate |
up to 14/min. |
Weldable
Material |
Mild Steel,
Stainless Steel |
| |
Aluminum |
| Pin/Stud Range |
14 GA, thru
3/8' Dia. weld base. |
| Weld Voltage |
34-175 VDC |
| Weld Mode |
Contact Cuphead |
| Power Requirement |
115VAC, 60
Hz, 30 AMP |
|
WELD GUN |
(CD - 2P PRECISION) |
| |
| Weight |
1-1/2 Lbs.(Not including cable) |
| Size (LWH) |
6-1/2' x 2" x 5-3/4" |
| Weldable Dia |
1/4 Gauge through 3/8" Dia. |
| Materials |
High strength,impact
resistance,
Polycarbonate |
| |
|
| CABLES |
|
| Ground cable |
# 1x15ft.(One each) |
Gun Extension
Set |
# 1x18/2 x 35ft.
(direct to gun) |
|
|
|
|
Please fill in the form below to receive a prompt quote or call 800-852-8352.
|
