800.852.8352
Midwest Fasteners, Inc.
450 Richard St.
Miamisburg, OH 45342
|
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
1 |
| SECTION I - PRODUCT AND COMPANY INFORMATION |
Product Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| CAS Number : |
MIXTURE |
| Hazard Rating : |
Health: 2 Fire: 3 Reactivity: 0 PPI: B |
| Company Identification : |
ITW TACC
AIR STATION INDUSTRIAL PARK
ROCKLAND MA 02370 |
| Telephone/Fax : |
(781) 878-7015 (781) 871-6727 |
| Chemtrec (24 Hour) : |
(800) 424-9300 |
| Trade Name : |
MIDWEST FASTENERS IHA-177 ADH |
| Product Code : |
MID003, MID004 |
| DOT Hazard Class : |
3 |
| UN Number : |
1133 |
| Shipping Name : |
ADHESIVES |
| Packing Group : |
II |
| SECTION II - HAZARDOUS INFORMATION |
Ingredient Name
|
CAS Number |
Percent |
TSCA |
| TOLUENE |
108-88-3 |
7-13 |
Y |
| HEXANE |
110-54-3 |
7-13 |
Y |
| LIGHT ALIPHATIC NAPHTHA |
64742-89-8 |
3-10 |
Y |
| HEPTANE |
142-82-5 |
3-10 |
Y |
| CYCLOHEXANE |
110-82-7 |
1-5 |
Y |
| SILICA, QUARTZ |
14808-60-7 |
0.5-1.0 |
Y |
Respirable crystalline silica (quartz) can cause silicosis, a
fibrosis (scarring) of the lungs. Silicosis may be progressive;
it many lead to disability and death.
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
2 |
Crystalline silica (quartz) inhaled from occupational sources is
classified as carcinogenic to humans.
| SECTION III - PHYSICAL DATA |
Appearance/Color :
|
BEIGE/CREAM |
| Boiling Range : |
156.∙F |
| Evaporation Rate : |
Faster than n-Butyl Acetate |
| % Volatile Weight : |
36.6% |
| % Volatile Volume : |
Not Available |
| Specific Gravity : |
1.08 |
| Weight/Volume Measure : |
9.00 |
| EPA Method 24 VOC : |
394.6 g/L |
| Photo Chem Reactive Only VOC : |
394.6 |
| SECTION IV - FIRE AND EXPLOSION HAZARD DANGER |
Flammability Class :
|
IB |
| Flash Range : |
0 F
Tag Closed Cup |
| Explosive Range : |
0.9%
7.5% |
| EXTINGUISHING MEDIA : |
| Foam, dry chemical, carbon dioxide, water spray or fog. |
| SPECIAL FIREFIGHTING PROCEDURES : |
| Wear a self-contained breathing apparatus. |
| UNUSUAL FIRE & EXPLOSION HAZARDS : |
Vapors are heavier than air and may travel to an ignition source
distant from the material handling point. |
| SECTION V - HEALTH HAZARD DATA |
| PERMISSIBLE EXPOSURE LEVEL : |
| SEE SECTION VIII. |
| EFFECTS OF OVEREXPOSURE : |
| INGESTION : |
Can cause gastrointestinal irritation, nausea and
vomiting. Aspiration of material into lungs may cause chemical
pneumonitis which can be fatal. |
| INHALATION : |
May cause nose or throat irritation. High concen- |
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
3 |
| trations may cause acute central nervous system depression
characterized by headaches, dizziness, nausea and confusion. |
| EYES : |
May cause severe eye irritation and corneal damage. |
| SKIN : |
May cause dermatitis. May cause defatting and irritation
of the skin. |
| FIRST AID: |
| EYES : |
Flush with large amounts of water, lifting upper and lower
lids occasionally. Get medical attention.
SKIN: Prolonged or repeated contact can cause irritation and possible
defatting of skin. |
| INGESTION : |
Do not induce vomiting, keep person warm, quiet, and
get medical attention (aspiration of this material into the
lungs due to vomiting can cause chemical pneumonitis which can be
fatal. |
| INHALATION : |
Remove individual to fresh air and if breathing is
difficult, administer oxygen. |
| SECTION VI - REACTIVITY DATA |
| Stability : |
This product is stable |
| Hazardous Polymerization: |
Hazardous polymerization will not occur |
| INCOMPATIBILITY : |
| Strong oxidizing agents, strong acids and bases. |
| CONDITIONS TO AVOID : |
| Fire, sparks, static electricity. |
| HAZARDOUS DECOMPOSITION PRODUCTS: |
| Carbon monoxide, carbon dioxide. |
| SECTION VII - SPILL OR LEAK PROCEDURES |
| STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED : |
Keep spectators away. Eliminate all ignition sources (flames,
hot surfaces and sources of electrical, static or frictional
sparks). Dike and contain spill with inert material (e.g. sand,
earth). Transfer liquids to covered metal containers for
recovery or disposal, or remove with inert absorbent. Use only
non-sparking tools. Place absorbent diking materials in
covered metal containers for disposal. Prevent contamination of
sewers, streams and groundwater with spilled material or used
absorbent. |
| WASTE DISPOSAL METHOD : |
| Dispose in accordance with federal, state and local regulations. |
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
4 |
| SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION |
Occupational Exposure Limits:
|
ACGIH TLV |
ACGIH TLV-C |
ACGIH STEL |
OSHA STEL |
OSHA PEL |
| TOLUENE |
50.00 PPM |
N/est |
N/est |
N/est |
200.00 PPM |
| HEXANE |
400.00 PPM |
N/est |
500.00 PPM |
N/est |
500.00 PPM |
| LIGHT ALIPHATIC NAPHTHA |
100.00 PPM |
N/est |
N/est |
N/est |
500.00 PPM |
| HEPTANE |
400.00 PPM |
N/est |
500.00 PPM |
500.00 PPM |
500.00 PPM |
| CYCLOHEXANE |
200.00 PPM |
N/est |
N/est |
N/est |
200.00 PPM |
| SILICA, QUARTZ |
0.10 mg/M3 |
N/est |
N/est |
N/est |
0.10 mg/M3 |
| RESPIRATORY PROTECTION : |
| If workplace exposure limit of product is exceeded, a NIOSH/MSHA
approved air supplied respirator must be used in absence of proper
environmental control. Engineering or administrative controls
should be implemented to reduce exposure. |
| VENTILATION : |
| Provide sufficent mechanical (general and/or local exhaust)
ventilation to maintain exposure below PEL. |
| PROTECTIVE GLOVES : |
| Chemical resistant gloves. |
| EYE PROTECTION : |
| Chemical splash goggles in compliance with OSHA regulations are
advised. |
| OTHER PROTECTIVE EQUIPMENT : |
| To prevent repeated, prolonged skin contact, wear impervious
clothing and boots. |
| SECTION IX - SPECIAL PRECAUTIONS |
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
5 |
| PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: |
| Keep container closed when not in use. Store at 60-95 degrees F
and out of the sun. Use adequate ventilation to avoid breathing
vapors when cover is removed. Ground all equipment when
handling flammable solventborne materials. |
| OTHER PRECAUTIONS : |
For professional or industrial use only. Follow label instructions.
Keep out of the reach of children. Not for consumption. No smoking.
Do not breathe fumes. Avoid contact with body. Turn off all pilot
lights, flames, stoves, heaters, electric motors, welding equipment
and other sources of ignition. Close all containers when not in use.
Empty containers must not be washed and re-used for any purpose.
Contact lens wearers take appropriate precautions. Wash hands
throughly after handling.
For spray applications, use only with approved spray equipment.
For flammable products, vapors may cause flash fire or ignite
explosively. To prevent buildup of vapors, use adequate ventilation
(e.g. open all windows and doors to achieve cross-ventilation).
Containers may be hazardous when empty. Never use welding or cutting
torch on or near container. |
| SECTION X - ADDITIONAL REGULATORY INFORMATION |
| -SARA TITLE III SECTION 313 : |
| This product contains the following toxic chemicals subject to the
reporting requirements of Section 313 of the Emergency Planning and
Community Right to Know Act of 1986 and of 40 CFR 372: |
| Ingredient Name |
CAS Number |
Percent |
| TOLUENE |
108-88-3 |
7-13 |
| HEXANE |
110-54-3 |
7-13 |
| CYCLOHEXANE |
110-82-7 |
1-5 |
-PROP 65 (CARCINOGEN)
WARNING: This product contains a chemical known to the state of
California to cause cancer. |
| Ingredient Name |
CAS Number |
Percent |
| SILICA, QUARTZ |
14808-60-7 |
0.5-1.0 |
| SECTION IX - SPECIAL PRECAUTIONS |
MATERIAL SAFETY DATA SHEET |
MSDS Name :
|
MIDWEST FASTENERS IHA-177 ADHESIVE |
| MSDS Number : |
MID003 |
| MSDS Last Updated : |
MAR-08-2007 |
Printed On : |
03/08/07 |
| Page Number: |
6 |
-PROP 65 (TERATOGEN)
WARNING: This product contains a chemical known to the state of
California to cause birth defects or other reproductive harm. |
| Ingredient Name |
CAS Number |
Percent |
| TOLUENE |
108-88-3 |
7-13 |
| The following ingredients are registered for TSCA 12B |
| Ingredient Name |
CAS Number |
Percent |
| HEXANE |
110-54-3 |
7-13 |
| SILICA, QUARTZ |
110-82-7 |
1-5 |
DISCLAIMER |
****** NOTICE ****** |
| This information is furnished without warranty, expressed or
implied, except that it is accurate to the best knowledge of ITW
TACC. The data on this sheet relates only to the specific material
designated herein. ITW TACC assumes no legal responsibility for use
or reliance upon these data. |
|
|
|
Please fill in the form below to receive a prompt quote or call 800-852-8352.
|
